OVERSUSPENSION KIT INSTALLATION MANUAL DUCATI V2

We recommend that the kit be installed by a specialised workshop.

Required tools:

1. Torque wrench and socket for tightening the motorcycle axle nut.
2. Small torque wrench and Allen key for tightening the clamp screws.
3. Medium-strength threadlocker, Loctite 243 type.

The resonator is mounted on the right side of the swingarm, except on motorcycles with a single-sided swingarm.

Next, attach the clamp with the resonator inside to the support, following the instructions below.

Respect the 23 mm measurement from the lower edge of the resonator to the clamp. Tightening torques: central bolt 2.2 Nm, the other two 1.8 Nm.

Calibration

1. Turn the red knob towards the + sign until it stops: the spring has the minimum preload and the mass oscillates with greater amplitude and lower frequency.
2. Ride the motorcycle and pay attention to how the swingarm moves on rough ground, when entering corners, under hard braking and while leaned over in a corner.
3. Turn the knob towards the − sign and you will notice those sensations change. Leave it in the position where you feel the least oscillation at the rear and a more direct feel with the suspension.

When you check the torque of your motorcycle's main bolts, include these screws in your check.